H.R. 888 — Introduced in House

I 113th CONGRESS 1st Session H. R. 888 IN THE HOUSE OF REPRESENTATIVES February 28, 2013 Mr. Pompeo (for himself, Mr. Matheson, Mr. Long, and Mr. Latta) introduced the following bill; which was referred to the Committee on Energy and Commerce A BILL To amend section 112(r) of the Clean Air Act (relating to prevention of accidental releases). 1. Short title This Act may be cited as the General Duty Clarification Act of 2013. 2. Prevention of accidental releases (a) Purpose and general duty Paragraph (1) of section 112(r) of the Clean Air Act (42 U.S.C. 7412(r)) is amended— (1) by striking It shall be the objective and inserting the following: (A) In general It shall be the objective ; and (2) by adding at the end the following: (B) Regulations (i) Regulations Not later than 12 months after the date of enactment of the General Duty Clarification Act of 2013, the Administrator shall promulgate regulations establishing criteria defining, for purposes of this paragraph, the terms extremely hazardous substance, appropriate hazard assessment techniques, and design and maintain a safe facility. (ii) Uniformity Not later than 18 months after the date of enactment of the General Duty Clarification Act of 2013, the Administrator shall issue guidelines to ensure that enforcement of this paragraph is handled by the regional offices of the Environmental Protection Agency in a uniform and appropriate manner across all regions of the United States. . (b) Definition of accidental release Subparagraph (A) of section 112(r)(2) of the Clean Air Act (42 U.S.C. 7412(r)(2)) is amended by inserting before the period at the end the following: , other than such an emission resulting from an act intended to cause harm. (c) Designs, approaches or technologies Subsection (r) of section 112 of the Clean Air Act (42 U.S.C. 7412(r)) is amended by adding at the end the following: (12) Designs, approaches, or technologies In exercising any authority under this subsection, the Administrator shall not, directly or indirectly, impose any obligation on any owner or operator of any stationary source to consider or implement particular designs, approaches, or technologies relating to manufacturing, processing, handling, or storage. .