,i  #aafth ,,congress  #ast ,session    
,h4 ,r4 #cbic  ,,in ,,the ,,house ,,of  
,,representatives  ,june #ad1 #bjai,mr4 
,engel 7for himself1 ,mr4 ,moolenaar1   
and ,mr4 ,trone7 introduced the         
following bill2 which was referred to   
the ,committee on ,transportation and   
,infrastructure1 and in addition to the 
,committee on ,energy and ,commerce1 for
 a period to be subsequently determined 
by the ,speaker1 in each case for       
consideration of such provisions as fall
 within the jurisdiction of the         
committee concerned  ,a ,,bill  ,to     
amend title #di1 ,united ,states ,code1 
to permit the installation of pulsating 
light systems for high mounted stop     
lamps1 and for other purposes4  #a4     
,short title ,this ,act may be cited as 
the ,collision ,avoidance ,systems ,act 
of #bjai4  #b4 ,rear-end collision      
avoidance systems  7a7 ,amendment       
,subchapter ,,ii of chapter #cja of part
 ,a of subtitle ,,vi of title #di1      
,united ,states ,code1 is amended by    

adding at the end the following new     
section3  #cjabi4 ,rear-end collision   
avoidance systems  7a7 ,pulsating light 
systems allowed ,a passenger car1       
multipurpose passenger vehicle1 truck1  
or bus may be equipped with a pulsating 
light system4  7b7 ,definition ,as used 
in this section1 pulsating light system 
means a system for a high mounted stop  
lamp in which-- 7#a7 when the brake of  
the vehicle is applied1 the lamp pulses 
rapidly no more than four times and for 
no more than two seconds and then       
converts to a continuous light as a     
normal stop lamp until the time that the
 brake is released2 and  7#b7 the rapid 
pulsing described in paragraph 7#a7 may 
not be repeated upon a subsequent       
application of the brakes for a lock-out
 period of at least five seconds after  
the release of the brake described in   
paragraph 7#a74  4  7b7 ,revision to    
,code of ,federal ,regulations ,not     
later than #ahj days after the date of  
enactment of this ,act1 the ,secretary  

of ,transportation shall update the     
entry for high mounted stop lamp in     
,table #a-;a of section #ega4ajh of     
title #di1 ,code of ,federal            
,regulations1 in accordance with the    
amendment made by subsection 7a74  7c7  
,technical and conforming amendment ,the
 table of sections for subchapter ,,ii  
of chapter #cja of part ,a of subtitle  
,,vi of title #di1 ,united ,states      
,code1 is amended by adding at the end  
the following new item3  #cjabi4        
,rear-end collision avoidance systems4  
4