,i  #aaeth ,,congress  #ast ,session    
,h4 ,r4 #biee  ,,in ,,the ,,house ,,of  
,,representatives  ,june #bj1 #bjag,mr4 
,engel introduced the following bill2   
which was referred to the ,committee on 
,transportation and ,infrastructure1 and
 in addition to the ,committee on       
,energy and ,commerce1 for a period to  
be subsequently determined by the       
,speaker1 in each case for consideration
 of such provisions as fall within the  
jurisdiction of the committee concerned 
,a ,,bill  ,to amend title #di1 ,united 
,states ,code1 to permit the            
installation of pulsating light systems 
for high mounted stop lamps1 and for    
other purposes4  #a4 ,short title ,this 
,act may be cited as the ,collision     
,avoidance ,systems ,act of #bjag4  #b4 
,rear-end collision avoidance systems   
7a7 ,amendment ,subchapter ,,ii of      
chapter #cja of part ,a of subtitle ,,vi
 of title #di1 ,united ,states ,code1 is
 amended by adding at the end the       
following new section3  #cjabi4         

,rear-end collision avoidance systems   
7a7 ,pulsating light systems allowed ,a 
passenger car1 multipurpose passenger   
vehicle1 truck1 or bus may be equipped  
with a pulsating light system4  7b7     
,definition ,as used in this section1   
pulsating light system means a system   
for a high mounted stop lamp in which-- 
7#a7 when the brake of the vehicle is   
applied1 the lamp pulses rapidly no more
 than four times and for no more than   
two seconds and then converts to a      
continuous light as a normal stop lamp  
until the time that the brake is        
released2 and  7#b7 the rapid pulsing   
described in paragraph 7#a7 may not be  
repeated upon a subsequent application  
of the brakes for a lock-out period of  
at least five seconds after the release 
of the brake described in paragraph     
7#a74  4  7b7 ,revision to ,code of     
,federal ,regulations ,not later than   
#ahj days after the date of enactment of
 this ,act1 the ,secretary of           
,transportation shall update the entry  

for high mounted stop lamp in ,table    
#a-;a of section #ega4ajh of title #di1 
,code of ,federal ,regulations1 in      
accordance with the amendment made by   
subsection 7a74  7c7 ,technical and     
conforming amendment ,the table of      
sections for subchapter ,,ii of chapter 
#cja of part ,a of subtitle ,,vi of     
title #di1 ,united ,states ,code1 is    
amended by adding at the end the        
following new item3  #cjabi4 ,rear-end  
collision avoidance systems4  4